High Mast Light Pole
APPLICATION:
High mast lighting is the most efficient method of lighting large area with the minimum obstruction. Technopole is the leading high mast light pole manufacturers in UAE.
GENERAL
Technopole Industries offers a raising and lowering system that allows for ease of maintaining the lighting system at ground level. Ideal where lift trucks and/or
climbing is prohibited. Light fixtures can be arranged symmetrically for lighting prison yards, roadways or parking lots. Not to be excluded is Sports Lighting.
The lowering device can also arrange light fixtures asymmetrically. This will allow for multiple sports fixtures to be aimed in one direction. Technopole is the leading high mast light pole manufacturers in UAE. Contact us for further details.
DESIGN
The selection of the correct pole design is predicated on the specific loading requirements of each application.
FINISH
All poles, mounting brackets and platforms are furnished with hot-dip galvanizing to BS EN 1461.Exterior finish coatings are available by request
POLE SHAFT
The steel pole shall consist of the appropriate number of pole sections, either round or multi-sided, for heights up to 38 Meters. Each section shall be fabricated from high strength low alloy steel conforming to EN 10025, with minimum yield strength of 55,000psi. These shafts shall telescope over each other to match the overall desired pole height. The overlap telescoping joint shall have a length that is the larger of 0.6 Meters or 1-1/2 times the diameter of the inside of the female tube. The sections shall be pre-fitted and match marked at the factory.
BASE PLATE
The base plate is fabricated from a structural quality hot rolled carbon steel plate that meets or exceeds ASTM A-36 with a minimum yield of strength of 36,000
psi. The base plate shall telescope the pole shaft and have a circumferential weld on the top and bottom.
ANCHOR BOLTS
Anchor bolts are fabricated from a commercial quality hot-rolled carbon steel bar that meets or exceeds minimum yield strength of 55,000 psi. Anchor bolts are
sized according to each pole design and are furnished with 2 galvanized heavy hex nuts and 2 galvanized flat washers. Anchor bolts shall be galvanized
|
|
|
|
|
|